Komatsu HB215LC-3, Руководство по эксплуатации и техническому обслуживанию

Страница: 213 / 492

4.
Remove the oil filler cap (F).
5.
Turn on the master switch (4) for the refuel auto stop sys-
tem on the refuel switch box (3).
The refuel switch box (3) is located inside the door on the
rear right of the machine.
6.
Press the switch (5) once to start the refuelling.
The refuelling automatically continues until the fuel tank
becomes full (the refuelling pump stops when the float
switch (6) reaches the upper limit).
Stop the machine on a level ground, and keep a close
watch on the refuelling to avoid the fuel spillage and over-
flow.
The refuelling can be stopped anytime by turning off the
master switch (4).
Keep pressing the switch (5) to further refuel the fuel tank
with fuel after the float switch stopped the refuelling pump.
Keep pressing the switch (5), then the refuelling pump
makes the fuel tank full.
Releasing the switch (5) stops the refuelling pump in this
state that the refuel auto stop system is cancelled.
When using this cancelling of the refuel auto stop system,
keep a close watch on the fuel level in the fuel tank to prevent the fuel from spilling and overflowing.
If the fuel is spilled out, turn off the master switch (4) and stop the refuelling immediately.
7.
Check that the master switch (4) is returned to OFF posi-
tion after the refuelling is completed.
A float gauge (G) rise out of the filler neck of the tank when
it is nearing full capacity.
Position of tip (a) of float gauge (G) when fuel tank is full:
Approximately 50 mm
8.
Perform the following to clear up after the refuelling is
completed.
OPERATION MACHINE OPERATIONS AND CONTROLS
3-141