Kohler K-3363, Руководство пользователя

Страница: 182 / 220

1022476-2-
B
6
Kohler Co.
Install water--resistant
wall material so the
paperbound edge is at
least 1/4” (6mm)
above the finished,
concave surface of the
module
Stud
Concave Surface
Apply a
continuous bead
of silicone sealant
to the nailing--in
flanges
Furring
Strip
4. Complete the Finished Wall
-
If you have not already done so, carefully remove the protective tape from the module surfaces.
-
Cover the framing with water-resistant wall material so the paperbound edges are within 1/4” (6mm) of the
finished, concave surface of the module. Seal the joints between the module edges and the water-resistant wall
material with silicone sealant.
-
Tape and mud the water-resistant wall material. Install the finished wall to the water-resistant wall material. Seal
the joints between the module rim and the finished wall material with silicone sealant.
5. Complete the Installation
-
Install any extra grab bars or towel bars to the bridging previously installed. Follow the accessory manufacturer’s
instructions.
-
Install the shower door according to the manufacturer’s instructions.
6. Clean-up After Installation
-
When cleaning up after installation, do not use abrasive cleansers as they may scratch and dull the surface. Use
warm water and a liquid, non-abrasive detergent to clean the surface.
-
Remove stubborn stains, paint, or tar with turpentine or paint thinner.
-
Do not allow cleaners containing petroleum distillates to remain in contact with the module surface for any length
of time.
-
Remove plaster by scraping with a wood edge. Do not use metal or wire tools. Use a powder-type detergent on a
damp cloth to provide mild abrasive action to the residual plaster.
Spec Seq#: 114
482971