Kohler K-3363, Руководство пользователя

Страница: 181 / 220

1022476-2-
B
5
Kohler Co.
Stud
Nailing-In
Flange
Use the pre--drilled
holes in the
nailing--in flanges
Use #6 large--head
galvanized nails to
secure the nailing--in
flanges to the studs
Nail 1/4” (6mm) thick
furring strips to shim
out to the edge of the
nailing--in flange
2. Install the Module
-
Remove the packaging from the front of the module.
-
Install K-9459 Sonata Accessory Kit according the the instructions packed in the kit.
-
Install the drain to the shower module according to the drain manufacturer’s instructions.
-
Use a drop cloth or similar material to protect the bottom surface of the module.
-
Lay out and mark the location of the mixing valve, shower, and bath spout holes as required on the back
(unfinished) surface of the module wall. Drill 1/4” (6mm) pilot holes at the marked locations.
-
From inside the module (finished surface), use a hole saw of the correct diameter to carefully drill the fitting
holes. Refer to the fitting manufacturer’s instructions to determine the correct hole sizes.
-
Clean the module to reduce the risk of surface damage.
-
With help, carefully move the module into the recess.
-
Be sure the bottom of the module is firmly supported against the floor. You may need to adjust some of the
framing. Use shims as necessary. However, no additional support is required. The module must be plumb and
level to ensure proper shower door installation.
-
Use #6 large-head galvanized nails to fasten the nailing-in flanges to the studs. Use the pre-drilled holes in the
nailing-in flanges. Be careful to avoid damaging the module surface - shim between the nailing-in flange and the
studs to fill any gaps.
3. Install the Plumbing
CAUTION: Risk of property damage. Ensure a watertight seal on the drain.
-
Connect the drain to the trap according to the drain manufacturer’s instructions.
NOTICE: An access panel will simplify future maintenance.
-
Install the shower, fill spout, valving, and supply connections as required. Strap the supply connections to the
stud framing. Provide access to the connections for future maintenance.
-
Connect the drain to the trap.
-
Open the hot and cold water supplies, and check the connections for leakage. Install the faucet trim according to
the manufacturer’s instructions.
-
Run water into the shower module, and check the drain connections for leakage.
Spec Seq#: 114
482971