Kodak I5X50 SERIES, Руководство по установке

Страница: 46 / 100

42 A-61848 / TWAIN October 2016
Automatically start scanning — if checked, and not scanning from
the flatbed, the scanner will wait up to 10 seconds for documents to be
placed in the input elevator before scanning will begin. In addition, once
the input elevator has been emptied, the scanner will automatically
resume scanning when paper is placed in the input elevator. The
scanner will wait the amount of time specified by the document feeder
timeout.
If this option is not checked, the scanner will go into a paused mode
and you can press the
Start/Resume button on the Operator Control
Panel to start scanning.
This option can be disabled to allow the operator the opportunity to
enable the
Overrides option from the scanner’s Operator Control Panel
before scanning begins.
NOTE: The Document Feeder settings are shared with all Setting
Shortcuts. Any changes will affect other shortcuts unless you
turn on the
Only save to this Setting Shortcut option.
Paper Destination — when sorting, the destination specifies the
default tray for paper that is not sorted. When not sorting, paper
destination can be used e.g. to send thick pages out the rear exit or to
send documents to the upper tray, for lead edge alignment.
•
Upper Tray : select this option to use the topmost output tray.
• Lower Tray : select this option to use the lower/normal output tray.
• Rear Exit : select this option to use the rear paper exit.
NOTES:
• This option is available for only the i5650S and i5850S scanners.
• For models that support this option, some selections may not be
available.
• For Rear Exit , make sure the space available behind the scanner
will allow paper to fully exit the scanner. Pull the scanner away
from any walls and clear any obstacles behind it, as needed.
Sheet Counter — enter the number to be assigned to the next physical
sheet of paper entering the scanner. This is incremented sequentially
by the scanner and is returned in the image header.
NOTE: Changing the sheet counter value will affect the Counter option
on the Device - Printer tab.
Diagnostics — displays the Diagnostics tab.