Knick Ceramat WA 153, Руководство пользователя

Страница: 26 / 44

26
Installing the Drive Unit
1) Before installing the drive unit in the process unit, check
whether the drive unit is in SERVICE position. Only then can
the drive unit be inserted sufficiently deep into the process
unit so that the groove can engage with the coupling nut.
2) When mounting the drive unit to the process unit, make sure
that the guiding grooves of the drive unit (A) engage with
the guiding bars of the process unit (B).
3) After successful alignment, you can insert the drive unit and
screw the coupling nut tight until it noticeably stops. Where
required, continue to press the drive unit in while screwing
the coupling nut to make screwing easier. Hand tighten the
coupling nut using the ZU 0648 Ceramat mounting wrench,
see “Accessories”, page 35.
ZU 0648
A
B
NOTICE
Be sure to follow these instructions in the correct sequence.