KNEGT 504G3 Series, Руководство по эксплуатации

Страница: 45 / 111

504G3
SERIES TRACTOR OPERATION MANUAL
43
Steering wheel can be adjusted forward or backward to make the operation of tractor
satisfactorily by following steps.
(1) Depress the the adjustment handle.
(2) Pulling the steering wheel backward or pushing it forward as your need.
4.2.3 Operating the Engine
•
Service Daily Before Start-Up
Park the tractor on flat ground before executing check.Check engine oil level.Remove
and clean the dipstick and reinsert fully.Remove and check the oil level.The safe
operating range is between upper and lower marks on the dipstick.
Do not operate the engine if the oil level is below minimum mark.In this case, add
recommended oil.
(1) Check prefilter of air cleaner.
(2) Check transmission/hydraulic oil level.Remove dipstict and clean it and reinsert
fully.Remove and check the oil level.Oil level should be between upper and lower
marks on the dipstick. If low, add oil.
(3) Drain water and sediment from fuel filter.
•
Before Starting the Engine
CAUTION:
Prevent asphyxiation.Engine exhaust fumes can cause sickness or
death to you or someone else. If you must operate engine in a building,be positive there
is adequate ventilation.Either use an exhaust pipe extension to remove the exhaust
fumes or open the doors and windows to bring enough outside air into the area.
(1)
Check fuel gauge to be sure that tractor has plenty of fuel.
(2)
Place shuttle shift lever in neutral,”N” position, and PTO switch in disengage
position.Starter does not operate if shuttle shift lever and PTO switch are not in
these position.
(3)
Place rock shaft position control lever in lower position.
(4)
Check charging system (battery) and oil pressure indicators.They glow when
ignition switch is turned to ON position. If any indicators do not function properly,
see your
Knegt
Dealer.
•
Start the Engine