KNEGT 504G3 Series, Руководство по эксплуатации

Страница: 50 / 111

504G3
SERIES TRACTOR OPERATION MANUAL
48
position.
Note
: Unequal traction keeps the lock engaged.
When traction equalizes, lock disengages itself by spring action. If lock does not
disengage, depress one brake pedal and then the other.
CAUTION
: Do not operate tractor at high speed or attempt to turn with differential
lock engaged. To prevent damage to drive train, do not engage differential lock when
one wheel is spinning and the other is completely stopped.
•
Use of the 4WD
When driving on icy, wet or gravel surface, reduce
speed and be sure tractor is properly ballasted to avoid
skidding and to prevent loss of steering control. Front
wheel drive provides better control under these road
conditions.
MFWD can be engaged or disengage while in
motion.See following steps:
(1) Depress the clutch pedal, then slowly release the
clutch pedal, and push the 4WD Lever down to
engage 4WD in time. So tractor is in 4WD mode.
(2) When stop or shift the gear, depress clutch pedal,
firstly pull the 4WD lever up to make 4WD disengage, then gear off and shut down
the engine or gear up needed gear.
Caution
: 4WD greatly increases traction. When using this option, extra caution is
needed on slops. Compare to two wheel drives, front wheel drive maintains traction on
steeper slops, increasing the possibility of a tip over.
Important: To extend service life of front tires life, enage front drive only when needed
in the field. Front tires turn slightly faster than rear tires with 4WD engaged and will
wear very quickly if driven in 4WD mode on hard surface for an extended period.
Unless absolutely necessary, do not engage 4WD when driving on hard surface.
•
Use of the hydraulic steering system
CAUTIONS
: Pay attention to the following messages to keep your safety and the
good condition of the tractor.