KNEGT 504G3 Series, Руководство по эксплуатации

Страница: 32 / 111

504G3
SERIES TRACTOR OPERATION MANUAL
30
Ⅱ
0.5 1 1 0.5
Ⅲ
0.5 1 1 0.5
Ⅳ
0.5 1 1 0.5
The front drive axle’s running-in is only allowed in fields or dirt roads. Only low
Ⅲ
gears can be used to running-in while the front drive axle is joining. Disengage the front
drive axle before the other gears running-in.
Attention must be paid to the process of the running-in:
(1) Whether the engine is running properly.
(2) Whether the clutch joint is smooth and whether the separation is complete.
(3) Whether the transmission of gearbox and changing gear is smooth
、
light. Whether
the gearbox has disorderly shop, automatic stripping phenomenon
(4) Whether the brake is reliable.
(5) Whether the front drive axle joint and separate is reliable.
(6) Whether the PTO’s joint and separation is reliable.
(7) Whether the differential lock joint and separate is reliable.
(8) Whether the electrical equipment and all kinds of instrument is working properly.
In process of running-in, if abnormal phenomena are found, the cause should be found,
and the running-in can be continued after the discharge.
3.7 Maintenance after running-in
After running-in, metal powders and dust will produce in the lubricant oil in the
transmission system. All lubricating oil and hydraulic oil should be cleaned and
replaced, carry out necessary technical maintenance before put tractor into normal use.
1. After the engine shutdown, drain out the oil in the sump and steering system when
it is still warm.Clean sump, oil filter,diesel filter, air filter and filter net in the
steering oil tank,after replace the core of diesel filter and oil filter,refill new oil as
per specified.
2. Drain out the oil in the transmission system and front axle when it is still warm;
meanwhile refill reasonable light diesel or kerosene. If the engine does not start,
use slow speed drag tractor forward or backward about 3 minutes or lift the front