KNEGT 504G3 Series, Руководство по эксплуатации, Страница: 58 / 111

504G3
SERIES TRACTOR OPERATION MANUAL
56
Disconnect cylinder hoses
IMPORTANT
: When disconnecting hoses, always grasp metal tip, never the hose itself.
Pulling on the hose instead of metal tip will eventually damage hose.
To disconnect hoses, grasp hose tip and give a firm pull.
4.3.3 Use 3 ­ Point Hitch
•
Attach Implement to 3 point hitch
1. Back tractor to implement so hitch point aligns.
2. Push hand throttle all the way forward and allow engine to idle for 1 to 2 min, then
turn off engine.
3. Slip draft links over implement to hitch pins on both sides and retains with locking
pins. When it is difficult to slip draft links over implement to hitch pins, operate as
following step:
1) Push down Plate (NO.1 in fig 4-24).
2) Pull back adjust draft link (NO.2 in fig 4-24), and slip adjust draft links over
implement to hitch pins on both sides and retains with locking pins.
3) Adjust draft links to initial postion and pull up Plate.
Fig 4-24
1
、
Plate
2
、
Adjust Draft Link
NOTE: Locking pins can be stored on draft links through holes in sway chain ears when
not in use.
4. To remove upper link from transport hook,
5. Attach upper link to implement topmost, retain with pin and locking pin.
6. Adjust upper link and lift links as necessary. (See Leveling the Hitch in this
section)