Knauer BlueShadow Detector 50D, Инструкция по эксплуатации

Страница: 23 / 72

21 Installation and initial startup
BlueShadow Detector 50D Instructions V7659
4.6 Computer control
The detector can be operated in different ways:
ƒ
Via the pin header
ƒ
Via the RS-232 port
ƒ
As part of a LAN, via the LAN connector of the router
All connectors for external control are located on the rear side of the
detector .
Legend
1
Power connection
2
Pin header
3
RS-232 port
4
LAN connector
5
Integrator output
Fig. 8: Connectors on rear side
Note:
HPLC devices from KNAUER only work with IP addresses, which
have been assigned by IPv4 . IPv6 is not supported .
This chapter describes how to set up a chromatography system in a local
area network (LAN) and how a network administrator can integrate this
LAN into your company network . The description applies to the operating
system Windows® and all conventional routers .
4.6.1 Setting up LAN
To set up a LAN, we recommend to use a router . That means the following
steps are required:
Process
1. On the computer, go to the control panel and check the LAN
properties .
2. Hook up the router to the devices and the computer .
3. Set up the router for the computer network .
4. Install the chromatography software .
5.
Switch on the device and run the chromatography software .
Configure LAN properties (see section „4 .6 .2“) .
1
2
3
4 5
Procedure
Next steps