KM SVS2000, Руководство по установке и эксплуатации, Страница: 71 / 89

67
www.kistlermorse.com
97-1129-01 Rev. D
InITIal SeTup oF uSer acceSS code
Follow this procedure to set up the user Access Code for the first time:
1. If the SVS2000 is in Run Mode, press the ‘9’ Key, ‘1’ Key, and Enter Key to access the menu tree. The
display shows:
91 USER ACCESS
2. Press the enter key to access this menu. The display shows:
nEW CODE? 0000
3. Use the numeric Keys to enter a one-,two-, three-, or four-digit number. Press the Enter Key to save the
Code in memory. The display acknowledges the entry and returns to:
91 USER ACCESS
4. Press an Arrow Key to scroll to another menu or press the Gross or net Key to return to Run Mode.
note: The Access Code is ‘activated’ 3 minutes after you leave Function mode. If you return to Function mode
after 3 minutes, you will be prompted to enter the code if you attempt to change a parameter. The tare key
continues to function without an Access Code.
change uSer acceSS code
Follow this procedure:
1. If the SVS2000 is in Run Mode, press the ‘9’ Key, ‘1’ Key, and Enter Key to access the menu tree. The
display shows:
91 USER ACCESS
2. Press the enter key to access this menu. The display shows:
USER CODE?
3. Use the numeric Keys to enter the current User Access Code. The number displays as ‘XXXX’ to prevent
anyone else from seeing the Code. Press the Enter Key. The display acknowledges the entry and
proceeds to:
nEW CODE?
4. Use the numeric Keys to enter a one-, two-, three-, or four-digit number for the new Code. Press the
enter key to save the Code in memory. The display acknowledges the entry and returns to:
91 USER ACCESS
5. Press an Arrow Key to scroll to another menu or press the Gross or net Key to return to Run Mode.
note: The Access Code is ‘activated’ 3 minutes after you leave Function mode. If you return to Function mode
after 3 minutes, you will be prompted to enter the code if you attempt to change a parameter.
92 KeyBoard locK
The SvS2000 arrives from the factory without a keyboard Lock Code in place, allowing the operator to tare the
system, zero the calibration, zero the totalizer, change the Run Mode display, and go into the menu tree at will.
The keyboard Lock function allows you to set up and/or change a keyboard Lock Code.