KM SVS2000, Руководство по установке и эксплуатации, Страница: 22 / 89

18
97-1129-01 Rev. D
www.kistlermorse.com
VI. SET-UP
The SVS2000 is designed to get you up and running quickly once the system is installed. The SVS2000 guides
you through the Quick Configuration questions. your responses provide the SvS2000 with the information
needed to pre-calibrate the system for your application.
Before you begin Quick Configuration, gather the information shown in Table 1 or 2 depending on product and
reference Figure 5.
When performing Quick Configuration, do not worry if you make an error. you can make changes by backing up
through Quick Configuration using the Func key. Alternatively, parameters can be changed in the menu tree after
you complete Quick Configuration, or the entire Quick Configuration can be repeated by defaulting the system.
Table 1. Quick Config: Bolt-On Sensor
Bolt-on Sensor Type options value Selected
Units Lbs or kg
Sensor Type (1) L-Cell or microcell
If Microcells (2)
Installed on horizontal legs? yes/no
Installed on vertical legs?
Rosette Arrays?
Vertical Mircocells? yes/no
Vessel Working Capacity Lbs or kg
Vessel Working Stress PSI or kg/mm2
Current Material Weight Lbs or kg
1. See the Application Data Form for sensor type and configuration, capacity, and stress. A copy of the
form was returned to you with your order. If you cannot locate the form, contact K-M to get another copy
before you proceed.
2. Internal calculations in the SVS2000 for Microcells are based on 3-inch Microcells on carbon steel.
modify the calibration after Quick Config is complete if the application is for installation on stainless steel
or aluminum or uses 2-inch Microcells.
Table 2. Quick Config: Direct Support Load Cell
direct Support Sensor options value Selected
Units Lbs or kg
rated Load Per Cell
Sensitivity mV/V
number of Supports per Vessel
Current Live Load