KM SVS2000, Руководство по установке и эксплуатации, Страница: 51 / 89

47
www.kistlermorse.com
97-1129-01 Rev. D
Figure 11. Set Point
SeTTIng up The SeTpoInTS
Follow this procedure to set up relay 1. The procedure for the other relay and for the digital outputs is similar.
1. If the SVS2000 is in Run Mode,press the ‘3’ Key, ‘1’ Key, and Enter Key to access the menu tree. The
display shows:
31 SLCT reLAy #1
2. Press the enter key to access this menu. The display shows:
reLAy1 vALue
3. Press the enter key to access the relay1 value menu. The display looks like this:
> 0 lbs
(Units are consistent with Disp Units.)
4. Use the numeric or Arrow Keys to input a value where you want the relay to energize. Press the Enter
key to save the value in memory. The display acknowledges the entry and returns to:
reLAy1 vALue
5. Press the up Arrow key to proceed to the next menu. The display shows:
reLAy1 DeADBAnD
6. Press the enter key to access the relay1 Deadband menu. The display looks like this:
> 10 lbs
(Units are consistent with Disp Units.)
7. Use the numeric or Arrow Keys to input the deadband. Press the Enter Key to save the value in memory.
The display acknowledges the entry and returns to:
reLAy1 DeADBAnD
8. Press the up Arrow key to proceed to the next menu. The display shows:
reLAy1 HI/LO
9. Press the enter key to access the relay1 Hi/Lo menu. The display looks like this:
reLAy1 On: *LO
(Asterisk indicates the current selection.)
If the displayed menu does not have the desired selection, press the Up Arrow Key to display the second
page of the menu (there are two pages to the relay Hi/Lo menu).