KM SVS2000, Руководство по установке и эксплуатации, Страница: 23 / 89

19
www.kistlermorse.com
97-1129-01 Rev. D
1. See the load cell label or the sensor manual rated load and sensitivity
Figure 5. Quick Config Terminology
Key FuncTIon
Enter
Press the Enter Key to save in memory any selection you make or any value entered.
each time the enter key is pressed, the SvS2000 briefly acknowledges the entry before
proceeding to the next display.
Arrow Keys
Press an Arrow Key to scroll the display through the selections at a given level. Press
the Up Arrow Key when the display shows the last selection in the menu to ‘roll over’ the
display to the first selection.
numeric Keys
Press the numeric Keys to type in numbers. If you make an error while typing a number but
have not pressed the enter key yet, do one of the following:
• Use the Arrow Keys to increase or decrease the number before you press the Enter
Key.
• Press the key for the first (left-most) digit in the number until the display ‘rolls over’ and
that digit appears as the only digit on the display. Then proceed to enter the remainder
of the number and press the Enter Key.
Func Key Press the Func key to back up through Quick Config to review and/or correct an entry.
Gross/net Key
Press the gross or net key to abort Quick Config and go to the gross or net display in run
Mode. The SVS2000 operates with factory defaults if you abort
nOTe: round numeric values to match the displayed format. For example, the display has two ‘dummy’ zeroes
for a bolt-on application working capacity. Round the working capacity to the nearest 100 lbs or 100 kg and
enter the digits that are to the left of the dummy zeroes.
Figure 6. Preparing Supplied Plug for Unused Openings
Sealant
Plug