9
VISION 2460 INSTALL GUIDE
4-wire harness
This input connects to the vehicle’s Hazard (turn signal) lights and works in
combination with the door Lock and Unlock inputs to inform the 2460 when
to Arm/Disarm. See
Fig-4
below.
Connect the WHT/RED wire as shown in
Fig-4
above (also shown on the
next page),
between the vehicle’s Light Flash Unit and the turn signal light.
The correct wire should show +24v when the turn signal light is illuminated.
WHT/RED
(+)24v Hazard Light Input
This input normally connects to the
Unlock
wire between the “door lock
relay control module” and the vehicle’s door lock actuator motors
(see page
10)
. This input is vital for the 2460 to know when to Disarm.
BLU/YEL
(+)24v Door UNLOCK Input
GRN/YEL
(+)24v Door LOCK Input
This input normally connects to the
Lock
wire between the “door lock relay
control module” and the vehicle’s door lock actuator motors
(see page 10)
.
This input is vital for the 2460 to know when to
Arm
.
All 3 connections on this page are very important.
Connecting them
incorrectly will result in malfunction of the 2460. NEVER use electrotaps!
Only use
PosiTap
connectors. Use
solder
only if you are experienced.
WARNING!
FIG-4: Connecting the Hazard Light Input
