11
© 2018 KIRAMEK, INC.
11
PROGRAMMABLE FEATURES
You can change some features of the 2460 by using the Program
Switch. Perform the following
5-step procedure
to change the fea-
tures shown below in
Table-2
:
1.
Start the engine and then Stop the engine.
(Required for Hybrid engines.)
2.
With the Ignition OFF, Arm the 2460 and then immediately Disarm.
3.
Within 20s, turn ON the Ignition.
4.
Press the Program Switch the same number of times as the feature you
want to program — refer to the “No.” column in
Table-2
below.
(For ex-
ample, to change “Ignition Trigger,” push the Program Switch 3 times.)
5.
Turn OFF the Ignition.
TABLE-2
Feature Selection Menu
No.
Feature Description
Toggle Settings
2
Require 2 Unlocks to Disarm
OFF
ON
3
Ignition Trigger
Enable
Disable
4
Parking Lights ON when IG ON
OFF
ON
5
Error Chirp
ON
OFF
6
Ignore Factory Unlock (Disarm) Signal
NO
YES
7
Parking Light Control
Solid-ON
Flashing
8
Auto Arm
OFF
ON
9
Horn or Siren Output
Pulsed
Continuous
10
Auto Rearm
OFF
ON
17
Exterior Illumination
OFF
ON
FACTORY DEFAULT SETTINGS SHOWN IN BOLD TEXT ABOVE
1)
After you complete Step-5 above, the Status LED will flash the same
number of times as the feature you just programmed. Because the set-
tings merely “toggle,” there’s no indication of the setting you toggled
to. Test your 2460 system to confirm your programmed settings. To
program another setting, repeat the 5 steps above.
2)
To Reset to Factory Defaults, see page 14.
NOTES
