5
© 2018 KIRAMEK, INC.
arming & disarming
MANUAL DISARMING
You can
manually
Disarm using a secure code in the event your
factory remote’s battery dies (see Note 2 below). The factory
code is “6”, but you can change this code to another number of
your choosing for greater security (see the bottom of this page).
1) Enter the vehicle.
(The horn/siren will blast. Door can be open or closed.)
2) Turn ON the Ignition.
3) Within 30s, press the Program Switch the same number of times as
your Disarm Code.
(Factory Default Code = 6)
4) Turn OFF the Ignition.
(The 2460 should Disarm and the horn/siren
should stop.)
1)
If the 2460 won’t Disarm in Step-4 above, you entered the code incor-
rectly. Start over from Step-2.
2)
Many Push Start vehicles don’t allow the Ignition to be switched on
in the absence of the Factory Remote. So if you lose or destroy your ve-
hicle’s remote, you may not be able to Manually Disarm the 2460. But if
your factory remote merely has a dead battery, you will be able to switch
on the Ignition and Manually Disarm using the 4 steps above.
NOTES
MANUAL DISARM CODE MODIFICATION
The factory code is “6” but you should change it to another number between 1 & 30:
1)
With the 2460
Disarmed
, switch ON the Ignition.
2)
Press the Program Switch for 6s, until the horn/siren will chirp 3 times.
3)
Release the Program Switch after you hear the 3 chirps, then turn OFF
the Ignition. The Status LED will light for 5s.
4)
Quickly switch ON the Ignition again (while the LED is lit for 5s).
5)
When the LED turns off, wait about 5s and you will see the LED start to
flash.
Take note of the flashes as the number of flashes will be the num
-
ber of your Disarm Code.
Turn OFF the Ignition to program your code.
The LED will then flash the same number of times as your Disarm Code.
If you added any optional VISION transmitters, you must relearn them.
PROGRAMMABLE
