V2.0
17
1 Driver installation requirements and precautions
1.1 Installation requirements
⚫
Please install in the indoor control box without rain and direct sunlight, and the surrounding items
should be non-flammable
⚫
The installation place should be no cutting fluid, oil mist, iron powder and chip
⚫
The installation place should be ventilated, dry and dust free,No vibration of the installation place
⚫
This product complies with EMC standards 2014/30 / EU and low voltage standards 2014/35 / EU
(LVD)
1.2 Installation environment
Environment
Condition
Operating temperature
0
℃
-40
℃
Operating humidity
5-95%
（
No condensation
）
Storage temperature
-10
℃
-70
℃
（
Not frozen
）
Storage humidity
5-95%
（
No condensation
）
Altitude
Rated power at 1000 m or below
1.3 Precautions
⚫
Don’t use gasoline, thinner, alcohol, acid or alkaline detergent to wipe the shell to avoid discoloration
or damage for the shell;
⚫
Please ensure that the environment is safe during transportation and storage. Please use the original
packaging for storage and transportation;
⚫
Please be familiar with the product knowledge and safety precautions before operating the driver;
⚫
Please strictly install the servo driver according to the installation method shown in Figure 1-1.
⚫
Driver and motor’s power cables, brake cables and encoder cables
cannot be over-stretched;
⚫
Avoid any foreign objects entering the driver, conductive foreign objects such as screws and metal
chips, or flammable foreign objects entering the driver may cause fire and electric shock. For safety
reasons, please do not use the servo driver with damage or parts damaged.
Warning!
⚫
Beware of electric shock.
⚫
Cable must be securely mounted to power interface
⚫
Be sure to disconnect the power when connecting the cables;
⚫
Contact with live parts can cause serious damage and may lead to death;
⚫
This product must be installed in the electric box to use, and all the protective measures have
been started.
⚫
When servicing, cleaning and prolonged service interruptions, be careful before touching live
parts
：
⚫
Turn off the power of the electrical equipment by the power switch and prevent it from turning on again
；
⚫
After the power is off, check the charge lamp on the front of the unit. If the light is off ,you can touch the driver.
