Kilsen KFP-AF Series, Руководство по установке

Страница: 59 / 80

Chapter 4: Maintenance
KFP-AF Series Installation Manual 55
Battery maintenance
The control panel requires two 12 V, 7.2, 12, or 18 Ah rechargeable sealed lead-
acid batteries. Compatible batteries for this product are shown in Table 10 below.
Batteries are located inside the control panel cabinet and must be installed in
series. Polarity must be observed. Connect batteries to the BAT connector on the
control panel PCB.
Table 10: Compatible batteries
Battery type Recommended batteries
12 V, 7.2 Ah Fiamm FG20721/2
Yuasa NP7-12 (GE order code B712)
12 V, 12 Ah Fiamm FG21201/2
Yuasa NP12-12 (GE order code B1212)
12 V, 18 Ah Fiamm FG21703
Yuasa NP17-12 (GE order code B1712)
Battery test fault indications
A flashing Supply Fault LED indicates a battery fault or a battery cable fault.
Additional information for the fault is displayed on the LCD, as shown below.
Table 11: Battery fault messages
LCD message Description
Battery high resistance FLT The batteries may be damaged or fully discharged
Battery fault The batteries may be damaged
Battery disconnected The batteries are disconnected or no batteries are installed
Battery short circuit There is a battery cable short circuit
If the control panel reports any of the above battery faults, check the battery
cables. If the cables are in good condition and all connections are correct, then
the batteries should be replaced immediately.
In addition to the above, the following battery charger faults may display:
• Battery charger: sensor HI
• Battery charger: sensor LO
• Battery charger: overvoltage
• Battery charger: undervoltage
• Battery charger: compensation