Kilsen KFP-AF Series, Руководство по установке

Страница: 47 / 80

Chapter 3: Configuration and commissioning
KFP-AF Series Installation Manual 43
Autosetup
Select this option to automatically configure installed loop devices. Autosetup
assigns a default configuration for each device type detected.
To begin autosetup:
1. Select Field setup from the main menu
2. Select Autosetup and then select the corresponding loop or All loops
During the search the LCD displays the message “Autosetup in progress…”.
When the autosetup is complete the list of detected devices is displayed.
3. Press F4 (Enter) and then press F2 (Exit)
4. Press F1 (Keep), F3 (Apply), F4 (Discard), or F2 (Exit)
Autosetup will:
• Assign all initiating devices (including zone modules) to zone 1.
• Assign all sounder devices to the sounder output group.
• Assign all non-supervised outputs (relays) to PRG1 group with all zones
active and with no delay. The initial zone will be 1.
Note:
Autosetup is incremental and retains the device text description for
previously configured devices.
Loop device configuration
Select this option to manually add devices or to change the default configuration
settings after autosetup.
To add a device or to change a device configuration:
1. Select Field setup from the main menu.
2. Select Loop device configuration.
3. Select the corresponding loop and device. For new devices, a message will
be displayed.
4. Make the required configuration changes (device type, operating mode, text
etc.).
5. Press F4 (Enter) and then press F2 (Exit).
6. Press F1 (Keep), F3 (Apply), F4 (Discard), or F2 (Exit).