Kilsen KFP-AF Series, Руководство по установке

Страница: 40 / 80

Chapter 3: Configuration and commissioning
36 KFP-AF Series Installation Manual
To change the control panel operation mode:
1. Select Panel setup from the main menu
2. Select Regional options
3. Select the operating mode.
4. Press F4 (Enter) and then press F2 (Exit)
5. Press F1 (Keep), F3 (Apply), F4 (Discard), or F2 (Exit)
Firenet configuration
Select Firenet to configure the control panel fire network and repeater settings
shown below.
Option Description
Firenet map Select this option to view all detected control panels, to add control
panels to the fire network, or to remove control panels from the
network. By default new control panels detected do not
communicate with the network.
Firenet mode Select this option to configure the control panel network operation
mode (standalone, networked panel, or networked repeater).
Repeater map Select this option to configure the control panels to repeat.
Allow control Select this option to configure global control options for networked
control panels and repeaters.
Class B Select this option to for a Class B network. When this option is
configured, no fault is reported for an open network.
Firenet map
The Firenet map defines the control panels (fire alarm or repeater panels) that
form part of the fire network. If a control panel previously configured to be in the
fire network is not detected, a message indicating it’s offline status (with the
panel ID) will be reported.
To change the fire network settings:
1. Select Panel setup from the main menu.
2. Select Firenet.
3. Select Firenet map. A list of detected control panels will appear on the LCD.
4. Select the control panel ID from the list and then select YES (to add the
control panel to the network) or NO (to remove the control panel from the
network).
5. Press F4 (Enter) and then press F2 (Exit).
6. Press F1 (Keep), F3 (Apply), F4 (Discard), or F2 (Exit).