Kilsen KFP-AF Series, Руководство по установке

Страница: 46 / 80

Chapter 3: Configuration and commissioning
42 KFP-AF Series Installation Manual
4. Press F4 (Enter) and then press F2 (Exit).
5. Press F1 (Keep), F3 (Apply), F4 (Discard), or F2 (Exit).
6. Remove the USB flash drive as described in “Removing a USB device” on
page 39.
Expansion board configuration
Select this option to add an installed loop, network, or zone expansion board to
the control panel configuration. By default repeater panels have the network
board configured as installed.
To add an expansion board:
1. Select Panel setup from the main menu
2. Select Expansion boards
3. The control panel will automatically detect any optional expansion boards
installed (you can change the board type if required)
4. Press F4 (Enter) and then press F2 (Exit)
5. Press F1 (Keep), F3 (Apply), F4 (Discard), or F2 (Exit)
If after, adding an expansion board, the board is not detected by the control
panel, a system fault is indicated.
Field configuration
Use the Field setup menu to access the field configuration options shown below.
Table 7: Field configuration
Option Description
Autosetup Select this option to automatically configure installed loop devices
to their default settings
Loop device configuration Select this option to manually configure installed loop devices or
change default settings
Zone configuration Select this option to configure zones
Panel I/O configuration Select this option to configure control panel input and output
functionality
Delays configuration Select this option to configure sounder and fire routing delays or to
program output activation (PRG)
Loops Class configuration Select this option to configure the installation loop wiring Class
(Class A or Class B)