Kikusui PAD-L III Series, Руководство по эксплуатации

Страница: 26 / 132

1-10 Setup PAD-L
1.5 Connecting the AC power cord
Connect the AC power cord to a switchboard sufficiently capable of handling the unit
input current, referring to "Power consumption chart" from Chapter 7,
"Specifications."
WARNING
• Connection of the AC power cord to the switchboard must be
carried out by qualified personnel.
• To prevent electric shock, turn off the switch on the switchboard
(to cut off the power feed from the switchboard) and then connect
the AC power cord.
• Install the AC power cord such that the distance between the
power supply and the switch on the switchboard is within 3 m.
This procedure facilitates operation of the switch on the
switchboard in the event of emergency.
If the distance to the switch on the switchboard is to be 3 m or
more, install the AC power cord with a separate switch provided
within 3 m from the power supply. For such a switch, use one with
two poles that can be disconnected simultaneously.
CAUTION
• Inside the unit, protective circuits including input fuses are
connected in order to meet the input terminal rating. Confirm that
the wires of the specified color are connected to the
corresponding terminals (L, N, and (GND) ). (This connection
must be performed by qualified personnel.)
Connecting procedure
1. Connect the supplied AC power cord to the AC input terminal board as
shown in Fig. 1-6.
WARNING
• For TYPE III model users
You cannot use the supplied AC power cord after changing the
input power voltage to 100 V. Instead, use a 3-core cabtyre cable
with a nominal sectional area of 8 mm
2
or greater. If you cannot
obtain such a cable, contact Kikusui distributor/agent.
3-core cabtyre cable
(8 mm
2 , approximately 4 m) (85-10-0441)