Keysight E6610A, Руководство пользователя и программирования

Страница: 73 / 108

12 SCPI Command Reference
Keysight E6610A User and Programming Guide 73
12 SCPI Command Reference
Introduction to SCPI on the E6610A
The E6610A SCPI interface supports the standard IEEE required and mandatory SCPI
commands, for example commands like “*IDN?” to identify the instrument and
“SYS:ERR?” to read the error status register.
The E6610A also supports a full set of SCPI commands, similar to those used on
industry-leading spectrum analyzers and signal generators to control the
measurement and signal playback functions. These commands are broken down into
the following subsystems according to the SCPI standard.
CONTROL Subsystem
For establishing connection to the E6610A and querying the RRH's IP address
SOURCE Subsystem
For setting up and configuring playback of CPRI and RF signals to be transmitted by
the E6610A
SENSE Subsystem
For configuring the E6610A's signal capture and measurement system to make
measurements
MEASURE Subsystem
The measurement sub-system has the following sections:
CONFIG: For configuring the E6610A’s RF and CPRI playback and capture system
INITIATE:To initiate a raw data capture from the measurement hardware
MEASURE:To initiate a new data capture and use the data to make a measurement
such as ACP, EVM, etc.
FETCH:To use an existing data capture to make a measurement such as ACP, EVM,
etc.
TRACE Subsystem
To export trace measurement data, such as ACLR plot traces, as text over the SCPI
interface. Similar to the MMEM commands, the trace commands allow the trace data
from various measurements like ACLR to be output as a series of text (CSV) numbers
directly over the SCPI connection.