Getting Started
Making a Basic Measurement
21
Making a Basic Measurement
This section provides information on basic analyzer
operations. It assumes that you are familiar with the
front and top panel buttons and keys, and display
annotations of your analyzer. If you are not, please refer
"Front Panel Overview" on page 5
, and
.
For more details on making measurements, please refer
to
“Making Measurements” on page 37
Entering Data
When setting measurement parameters, there are
several ways to enter or modify active function values:
1 Using the Front Panel Knob
Increases or decreases the current value.
2 Using the Arrow Keys
Increases or decreases the current value by the step unit
defined.
Press [FREQ] > {CF Step} to set the frequency by an
auto-coupled step (Step = Span/10, when {CF Step}
mode is set to Auto).
3 Using the Numeric Keypad
Enters a specific value. Then press a terminator key
(either a specified unit softkey or [ENTER]) to confirm
input.
4 Using the Unit Softkeys
Terminates a parameter value which requires a unit
input.
5 Using the Enter Key
Terminates an entry or confirms a selection.
Содержание N9340B
