Keysight Technologies N9322C, Руководство пользователя, Страница: 41 / 214

33
Functions and Measurements
Making a Basic Measurement
Viewing a Signal
Refer to the procedures below to view a signal.
1
Press
System > Pow on/off Preset > Preset Type > Factory
to enable
the factory- defined preset state.
2
Press
Preset
to restore the analyzer to its factory- defined
state.
3
Connect the 10 MHz
REF OUT
on the rear panel to the
front- panel
RF IN
.
Setting the Reference Level and Center Frequency
1
Press
Amplitude > 10 > dBm
to set 10 dBm reference level.
2
Press
Frequency > 30 > MHz
to set 30 MHz to center frequency.
Setting Frequency Span
Press
Span > 50 > MHz
to set 50 MHz frequency span.
Reading Frequency and Amplitude
1
Press
Peak Search
to place a marker (labeled 1) on the
10 MHz peak.
NOTE
Changing the reference level changes the amplitude value of the top
graticule line. Changing the center frequency changes the horizontal
placement of the signal on the display. Increasing the span will
increase the frequency range that appears horizontally across the
display.