Wirnet iBTS
Document title : Installation and
Maintenance Manual
Version : 2.0
Author : SNI
Date : 04/12/2018
Classification
This document is the strict property of Kerlink and shall not be either copied nor sent without express
written authorization of Kerlink
Internal Use
Kerlink m2m technologies reserved rights
Confidential
Kerlink – 1 rue Jacqueline Auriol – 35235 THORIGNÉ-FOUILLARD
Page 203 / 221
Strict confidential
The recommended cable section is 1.5 sq. mm.
The auxiliary power supply connector is a Euroblock plug, which is located on the front side
of the CPU module. The polarity of the power signals are indicated besides the connector, as
shown below:
Figure 158 : Auxiliary DC power supply connector
First, the auxiliary power supply cable must be introduced into the enclosure through a cable
gland. The operator needs to determine which cable gland can be used for this operation:
M25 cable gland can be used for that purpose if the Ethernet cable is no longer
required (LTE backhaul only).
If the Ethernet cable is required, then a M16 cable gland must be used. One M16
blind stops must be removed and replaced by the M16 cable gland.
Note 1:
The M16 cable glands are not provided by KERLINK.
The M25 cable gland allows external cable diameter from 5mm to 8 mm.
The M16 cable glands allows external cable diameter from 4mm to 8 mm.
After insertion through the cable gland, the 2-wire cable can be screwed to the dedicated
Euroblock plug as described on the Figure 158, according to the defined polarity.
Note 2:
the Euroblock plug must be inserted into the Euroblock receptacle only once all
other connections are settled and USIM card inserted (see §4.7).
Note 3:
the external power supply must be a limited power source.
