15
TK-5710
(
B
)
/5710H
(
B
)
INSTALLATION
4. Ignition Sense Cable (KCT-18:Option)
The KCT-18 is an optional cable to use the following
functions:
• Ignition function
The ignition function allows you to turn the transceiver's
power on and off with the ignition key of your car. When you
are driving with the ignition key on, the horn alert function is
disabled.
• Timed power-off function
The timed power-off function turns the transceiver's
power off the time specified with the programming
software (KPG-95D) after the ignition key is turned off.
When you are driving with the ignition key on, the horn alert
function is disabled.
The ignition sense function and the timed power-off
function can be used at the same time.
4-1. Connecting the KCT-18 cable to the transceiver
1. Remove the short plug from the accessory connector (9-
pin) on the rear of the transceiver.
2. Insert the KCT-18 lead terminal into pin 1 (IGN) of the
short plug (9-pin).
3. Connect the short plug to the accessory connector (9-pin)
on the rear of the transceiver.
Note:
You must setup using the KPG-95D.
4-2. Connecting the KCT-18 cable to the KRK-5/
6DH remote kit
1. Remove the square plug from the accessory connector
(12-pin) on the rear of the control head.
2. Cut off the end of the rubber cap (accessory), insert the
KCT-18 lead terminal into the rubber cap, and insert it into
pin 1 (IGN) of the square plug.
1
7
9
3
KCT-18
Short plug
(9-pin)
1
3
10
12
Rubber cap
Tie wrap
KCT-18
Cut
Square plug
(12-pin)
Fig. 4-1
Fig. 4-2
Display 1
Display 2
KCT-22
Control cable
KCT-22
Control cable
GND
GND
GND
GND
1
1
1
1
2
4
2
3
3
4
Cable
fitting
Cable
fitting
Transceiver
KRK-6DH
main panel
Fig. 3-2
3. Connect the square plug and rubber cap to the accessory
connector (12-pin) on the rear of the control head, then
clamp the bottom of the rubber cap with the supplied tie
wrap.
Note:
You must setup using the KPG-95D.