
12
TK-5710
(
B
)
/5710H
(
B
)
INSTALLATION
Fig. 1-4
Keytop insertion
Fig. 1-5
Keytop removal
2. Remote kit (KRK-5:Option)
The KRK-5 remote kit is used to remotely operate the
transceiver. The KRK-5 is connected to the KCH-14 or KCH-
15 with an optional KCT-22M (8 feet), KCT-22M2 (17 feet),
or KCT-22M3 (25 feet) control cable.
2-1. Installing the KRK-5 main panel onto the
transceiver
1. Remove the upper case and lower case of the trans-
ceiver.
2. Insert the lead wire with connector (W700) of the control
unit (X53-412) into the connector (CN4) of the KRK-5.
3. Install the KRK-5 main panel on the transceiver using four
screws (
z
).
Note:
Take care that the lead wire with connector (W700) is not
caught when fitting the KRK-5 main panel on the
transceiver.
4. Affixing the sheet (G11-4379-04) for the waterproof
(Fig.2-1-2).
(1) Remove the covering paper of the sheet (
x
).
(2) Affix the sheet while taking note of the position of the
three parts as shown in Fig.2-1-2 (
c
).
Firmly affix the sheet to the chassis by pushing the
double-coated tape with your fingers.
(3) Repeat step (2) to affix the sheet to the other side of
chassis.
Note:
The sheet cannot be reused. Affix a new sheet when you
removed the sheet.
5. Reassemble the upper case and lower case of the trans-
ceiver. (Refer to page 24)
Note:
Take care that the sheet (G11-4379-04) is not peeled off
when installing the upper / lower case.
Transceiver
Packing
W700
CN4
KRK-5 main panel
1
1
Fig. 2-1-1
GRP
VOL
CH
POWER
TX BUSY
PF1
PF2
PF3
PF4
PF5
GRP
POWER
TX
VOL
CH
BUSY
SCAN
OPT
OST
A
B
C
MON
CALL
SP
MON
SCN
PF1
PF2
PF3
PF4
PF5
PF9
PF8
PF7
PF6
KCH-14
KCH-15
Fig. 1-3