troubleshooting
solution
l
l
1
2
3
4
5
6
problem
The whisk or K-beater knocks against the bottom of the bowl or isn’t
reaching the ingredients in the bottom of the bowl.
Adjust the height. Here’s how:
Unplug.
Raise the mixer head and insert the whisk or beater.
Hold it, then loosen the nut
Lower the mixer head.
Adjust the height by turning the shaft. Ideally the whisk/K-beater should
be
almost
touching the bottom of the bowl
Raise the head, hold the whisk/K-beater and tighten the nut.
to fit and use your splashguard (if
supplied)
5
1
Raise the mixer head until it locks.
2
Fit the bowl onto the base.
3
Push the splashguard onto the underside of the mixer head
until fully
located. The hinged section should be positioned as shown.
4
Insert required tool.
5
Lower the mixer head.
l
During mixing, ingredients can be added directly to the bowl via the hinged
section of the splashguard
.
l
You do not need to remove the splashguard to change tools.
6
Remove the splashguard by raising the mixer head and sliding it down.
