ZHEJIANG KAYO MOTOR CO., LTD.
TS90 carburetor oil drain bolt ride. Therefore, the carburetor should be cleaned after
each ride to avoid the generation of grease stains and
affect the use of the carburetor.
The cleaning steps as follows:
1. Place a container under the carburetor for receiving
fuel
2. Turn off the fuel tank switch
3. Unscrew the drain bolt of the carburetor and wait
for the fuel to flow out
4. After the fuel is drained, screw the drain bolt back
CHECK THE SHIFT LEVER POSITION
Shift head
The inspection steps are as follows:
1. Raise the whole vehicle so that the center plane of
the tire is perpendicular to the ground
2. The line of sight is level with the tread surface, and
observe the position of the shift head
3. The shift head should be level with the tread surface
or slightly lower than the tread surface
If the shift head is higher than the tread surface, the
shift head should be adjusted downwards; if the shift
head is excessively lower than the tread surface, the
shift head should be adjusted upwards.
ADJUST THE SHIFT LEVER POSITION
Shift lever fixing bolt
Adjusting Steps are as follows:
1. Loosen the fixing bolts of the shift lever.
2. Remove the shift lever.
3. Turn the shift lever to a suitable position and install
the spline.
4.
Tighten the shift lever fixing bolt.
INSPECTION OR REPLACEMENT OF
SPARK PLUGS
The engine spark plug torque is 25
～
30N•m.
The spark plug must be disassembled regularly to
check the distance between the electrodes (0.5 ~
0.8mm). If the spark plug contains oil or cinder, wipe it
off with a wire brush or similar. Use a measuring
www.kayomoto.com
