5
发动机
5- 16
5.4.7 Carburetor installation
Install the throttle valve plunger into the
carburetor body.
Note: The groove of the throttle valve
plunger should be aligned with the
locking screw on the carburetor body.
Then tighten the end cap of the top of the
carburetor
After installing the carburetor, adjust the
free stroke of the throttle handle with the
adjustment device on the throttle control
line.
Free stroke of the throttle handle: 2~6mm
5.4.8Air conditioning screw
adjustment
Rotate the locking screw clockwise until it
contacts the screw seat
Then turn in the opposite direction until the
standard position is reached.
Standard position of the locking screw: 7/4
turn
Note: If the locking screw and the screw
hole seat are tightened too tight, the screw
hole seat may be damaged.
Float
Assembly
Third ring groove
Decreas
e
Throttle Valve Screw
Throttle Valve Screw
Содержание AU200
