KAYO MOTOR AU200, Руководство по обслуживанию

Страница: 48 / 138

3
定期检查与调整
3-
16
3.8 Meter
Check meter
When the vehicle system is powered on for
the first time (or after the instrument is
replaced for the first time), when the engine
is not working, the speed should be in the
zero position, start the engine, pay attention
to whether the speed value indicates change,
if it does not change, it should be repaired in
time.
3.9 Lighting device
Front light axis adjustment
(Take the right front headlight as an example)
Adjust the bolt with a
“
Ten
”
screwdriver or
wrench 1. Adjust the low beam; adjust the
bolt 2 to adjust the up and down direction of
the headlight.
Note: The vehicle system requires power
before checking the lighting unit.
Turn signal inspection
Turn the turn signal switch 3 to the left and
right respectively to observe whether the
front and rear turn signals of the vehicle are
on. If it is not bright, please check if the line
is connected incorrectly. If the wiring is
correct, please replace the turn signal in
time.
Taillight inspection
Hold the brake lever with your hand and
observe the tail light. If the tail light is not
bright, please check if the line is connected
incorrectly. If the wiring is correct, please
replace the tail light in time.
Horn check
Hold down the horn switch 4 and observe
the horn. If the horn is not loud or the sound
is too light, please check if the line is
connected incorrectly. If the wiring is
correct, please replace the horn in time.
4
3
1
2