Kathrein UFS 910, Руководство по эксплуатации

Страница: 74 / 88

74
SERVICE MENU
USB DEVICE MANAGEMENT
This function can be used only if an external USB storage medium is connected at the rear of the receiver.
For this see also page 3 “Recording function (from software version 1.04)”
REMOTE CONTROL CODE
Select the “Service” menu using the menu button , the buttons on the main menu and .
Use the buttons to switch to “Remote control code” and to call it up press the button.
The following display appears:
You can now use the remote control for your receiver to set a new remote control code. Simultaneously
press buttons
+ + for remote control code 1 (standard setting)
+ + for remote control code 2
+ + for remote control code 3
+ + for remote control code 4
After changing the remote control code you must now set your remote control to the code you selected.
For this, simultaneously press buttons
+ for remote control code 1
+ for remote control code 2
+ for remote control code 3
+ for remote control code 4
Then press the button. If the receiver display does not close down, the receiver and the remote control
are not set to the same remote control code. Check your settings again.
This function is
unavailable on the
fi rst hardware version
of the UFS 910!
On this, the “Remote
control code”
selection fi eld is
greyed out and cannot
be selected.