13
REMOTE CONTROL
REMOTE CONTROL RC 660
The RC 660 remote control supports up to four units which are supplied as standard with the RC 660.
First switch all other receivers off at the power switch.
1. Setting up using the menu (from software version 1.04)
In the UFS 910 the remote control code in the “Service menu” is converted to “Remote control code”.
Note:
From software version 1.04 the remote control code can only be changed using the menu.
Manual changes are not saved by the receiver.
2. Manual setting (can be performed only if the software version is earlier than 1.04)
Switch on the relevant receiver.
On the remote control simultaneously press
address 1 =
+
+
Then switch the receiver off again at the power switch and do the same for the other units (
+
+
for the second receiver;
+
+
for the third receiver and
+
+
for the fourth receiver)
Make sure only one receiver is on at a time!
To switch the remote control to an infrared code:
When you have confi gured all receivers to their infrared code, to switch between units on the remote
control do the following:
For operating the fi rst receiver (address 1), press
+
, for the second receiver
+
,
for the third receiver
+
and for the fourth receiver
+
.
+
(red) = Kathrein UFD 5xx code for remote control RC 400
The RC 600 and RC 650 remote controls are not interchangeable!
Содержание UFS 910
