Kathrein UFS 910, Руководство по эксплуатации

Страница: 62 / 88

62
Network scan
Use the buttons (On/Off) to select whether a network scan should be performed. If you set the
network scan to “Off”, only the factory stored transponders of the satellites you previously selected will be
scanned for new as yet unlisted channels.
If you set the network scan to “On”, the transponder network enables additional transponders that have
not yet been stored to be located. They are then stored and scanned for new channels in the same way
as the existing transponders.
When you have made your settings, use the buttons to select “Start Search” and press the
button to start scanning. You can cancel the scan at any time by pressing the button. During the scan
you will see a display that shows you the progress of the scan and the channels found so far. Newly found
channels are identifi ed with the designation “New” after the
channel name.
After completion of the scan, you will see the following
message (example):
Press the button. You will be asked whether you wish to
save the changes or not. Selection is performed using the
buttons and is confi rmed using the button. If you
select “Yes, save changes”, the newly found channels will be added to the end of the channel list. Then press
the button to exit the menu. The channel list is called up on to the TV screen by pressing the button
(see also section “On-screen displays” “Channel list TV/Radio”).
CHANNEL SEARCH (CHANNEL SCAN)
CHANNEL SCAN WITH SERVICE ID
The buttons allow you to select different sets of parameters for the scan.
Satellite
Use the buttons to select the satellite that is transmitting the channels to be scanned.
Make sure your reception system is aligned to the selected satellite.
Press the button to move to the next selection item.