91
You can now use the remote control for your receiver to set a new remote control code (the remote
control code 1 is set as standard). Simultaneously press buttons:
-
+
+
for remote control code 1
-
+
+
for remote control code 2
-
+
+
for remote control code 3
-
+
+
for remote control code 4
Then press the
button. If the receiver display does not close down, the receiver and the remote
control are not set to the same remote control code. Check your settings again.
To set the remote control in future for whatever remote control code is required, proceed as follows:
-
+
for remote control code 1
-
+
for remote control code 2
-
+
for remote control code 3
-
+
for remote control code 4
If you have a further Kathrein receiver in use that was supplied with the RC 660
remote control, you can use the UFC 960sw remote control to operate that other
receiver also. On the RC 660 remote control, the codes for remotely controlling the
UFC 960sw begin with “5”:
+
= remote control code 1 for the RC 660,
+
= remote control code 2 for the RC 660,
+
= remote control code 3 for the RC 660,
+
= remote control code 4 for the RC 660
Main menu - Settings
