Kalmar ContChamp DRD S Series, Техническое руководство

Страница: 291 / 298

ContChamp DRD-S
Technical Handbook
Periodic supervision
5 S. Grupp 90
9407
04-10
LUBRICATION CHART
1)The interval is greatly dependent on the fuel and lubricant qual-
ity as well as the operating conditions.
If intervals longer than 200 hours are desired, the condition of the
oil must be checked by the company making the oil,
by means of regular lubricant tests.
2
) Note! DIfferent oils in brake and planetary gear.
(Volume brake: 0.6 l. Volume gear: 1.6 l)
For volumes, see Technical Data. For lubricating oil grades, see
Oil and lubricant recommendations
L=Lubricate
C=Check
Item
No. Description Interval
operating hours
No. of
lub.
points Remarks
200 600 1000
1 Boom mounting L 2
2 Slide plates, boom L Manually pump grease while the boom is
moved slowly outwards and inwards to its
end positions
3 Rotator mounting L 2
4 Tilt cylinders L 4
5 Rotator reduction gear
(Brake and planetary gear) x C xx 4 Check the level. Top up the red point on the
sight glasses
2)
x) First oil change at warranty service
xx) Thereafter oil change every 1000 h
6 Rotator bearing L 4 2 nipples on each side
7 Pinion and ring gear L 3 Brush on with grease
8 Link levers L 4
9 Steered wheel bearing 2 Remove, clean, inspect and pack with
grease every 4000 h
10 Knuckle pin bearings 4 Remove, clean, inspect and pack with
grease every 4000 h
11 Engine oil x
x) Change the oil every 200 h
1)
12 Engine oil filter x 2 x) Change the filter every 400 h
13 Gearbox oil C x 1 x) Change the oil. Check the level at idling
speed
14 Gearbox oil filter x 2 x) Change the filters
15 Hydraulic oil filter, working hydraulics x 2 x) Change the filters
16 Hydraulic oil filter, brake system cooling
circuit x 1 x) Change the filter
17 Hydraulic oil, servo system x 1 x) Change the filters
18 Hydraulic oil filter, top lift x 1 x) Change the filters
19 Propeller shaft L 3
20 Drive axle C x 3 Change the oil
21 Breather filters, hydraulic tank x 2 x) Change filters every 2000 h
22 Hydraulic oil C x x) Change oil every 2000 h
23 Door and panel hinges Lift off the doors and panels
24 Brake pedals C L 2 Check and retighten the pedal axle locking
screws. Lubricate axle nipples
25 Hydralic oil, brake system C x 1 x) Change the oil. N.B. Only machines with
separate tank for brake system
N.B.
If the truck is standing unused outdoors, with the
piston rods protruding, all piston rods must be
greased to prevent corrosion. After they have been washed with degreasing
agent, all pistons should be moved backwards
and forwards several times to obtain a new pro-
tective oil film.