Kalmar ContChamp DRD S Series, Техническое руководство

Страница: 177 / 298

ContChamp DRD-S
Technical Handbook
Engine
Service
15 S. Grupp 30
9407
04-10
Changing the oil and oil filter
N.B. Before draining the oil, make sure that it is at normal
working temperature.
1. Remove the drain plug from the underside of the sump and
drain the oil.
2. Clean the area round the filters and place a tray under the fil-
ters to collect any spillage.
3. Remove and discard the filter canisters, which are of dispos-
able type.
4. Pour clean oil into the centre of the new filters, wait until the oil
has seeped through the filter paper and top up until the filters
are full.
5. Lubricate the canister seals with oil.
6. Fit the new filters and tighten them - by hand only.
7. Fill the engine with oil (see Group 90, Lubrication chart).
8. Run the engine and check that no oil leaks at the filters.
9. Stop the engine and check the oil level after a few minutes.
Top up as necessary to the MAX level on the dipstick.
N.B. To avoid serious damage to the engine, use only
genuine Kalmar filters.
Checking the V-belt tension
1. Check at regular intervals that the V-belts are correctly
tensioned. It should not be possible to depress the V-belt more
than 10 - 12 mm mid-way between the pulleys.
2. The engines are equipped with an automatic belt tensioner
which maintains the belt tension constant.
N.B. If the belt drive consists of two belts, always change
both belts.