Kalmar ContChamp DRD S Series, Техническое руководство

Страница: 281 / 298

ContChamp DRD-S
Technical Handbook
Top-lift
Service
13 S. Grupp 80
9407
04-10
Adjustment and lubrication of sliding plates
The sliding plates are made of brass and must be thorougly lubri-
cated in order to minimize wear. The degree of wear is highly de-
pendant on the environment and may vary considerably.
Equally important is the play between fixed and moveable parts,
which is adjusted by means of shims.
Adjustment of play using shims.
1. Operate the length adjustment and check the play which
should be 1-2 mm on both sides of the moveable member,
horizontally as well as vertically.
2. If needed, disassemble the sliding plates in question and put
suitable shims under the sliding plates. Sliding plates are fitted
in the ends of each moveable member and also each end of
the fixed main beam, see figure.
Shims of various thickness can be ordered from Kalmar, see
Spare Parts Catalogue.
N.B. The shims must be fitted equilateral in order to maintain
the attachment aligned and levelled, otherwise there is a risk
of malfunction.
3. Check the remaining thickness of the sliding plates.
Minimum screw mesh: 5 mm. Minimum clearance between
sliding surface and screw tip: 3 mm.
If necessary when thick shims are needed, change to longer
screws, but note the 3 mm clearance between screw tip and slid-
ing surface.
Lubrication
1. Set the length adjustment to maximum.
2. Use a brush on a long handle to reach into the fixed main
beam. Grease the sliding surfaces on sides, roof and bottom
with a graphitebased grease.
Sliding plate location