K9Safety K9Caller, Руководство по установке

Страница: 23 / 28

Branch 8 Hot Temperature Start Setting
This is the programmable temperature setting that determines at what temperature the system
will start the vehicle based on High temperature. There are 3 factory settings that can be se-
lected via this feature. You can also change this setting via the remote control. See Remote
Controls ( c
° )
Branch 9 No Selection
Branch 10 Door/Trunk Pop Output Selection (Pin M10)
This setting selects whether the Aux 1 output will be used as a door pop or a trunk pop. As a
door pop, Aux 1 can only be triggered when the K9system is Activated and a valid signal is
received. As a trunk pop, Aux 1 will be triggered whenever a valid signal is received. Note,
the polarity can be changed between negative and positive depending on the jumper setting.
See Fig J1 on page 9. If you require door pop and trunk pop then use one of the aux channels
to perform trunk pop.
Branch 11 Hot Start Hysteresis
Hysteresis is an offset that determines the shutdown temperature for temperature activated
auto start. The default is 5 degrees which means if the start temperature is set to 75 degrees
then the cabin has to cool to 70 degrees before the engine will shut off.
Branch 12 Sensor Input/External Pop receiver
This setting selects whether Pin S2 Blue wire will act as a door pop trigger (Pro) when the K9
system is activated or as a alarm sensor input.
Branch 13 Remote Feature Lockout
This feature selects whether all the functions can be processed from the remote or only certain
ones. In lockout mode, the remote will not activate/deactivate the K9 system, change hot start,
or hot alert temperature.
Branch 14 Disarm before Pop/Trunk Output (Pin M1)
This feature selects if the system will disarm the alarm system before a door pop or trunk pop
to prevent the alarm from being triggered.
Branch 15 Rearm after M1 Pop Output
This feature selects if the system will rearm the alarm system after a door pop or trunk pop
Branch 16 Factory Alarm Disarm/Ignition
This setting chooses the type of output for Pin M10 between a factory disarm output or an
ignition output. Note, the polarity can be changed between negative and positive depending on
the jumper setting. See Fig J1 on page 9.
Programming Branch Description, Continued
Page 23