K-Sonic KS-2010, Руководство по эксплуатации

Страница: 52 / 54

51
Overload lamp light
on
z
Check if the tooling horn
cracked
z
Check if AC cooling fans
does not work cause of the
tooling horn temperature too
high
z
Replace the tooling horn
z
Replace the cooling fan
The working roller
and/or tooling horn
does not rotated or
smoothly turning
z
Check if 10 pin control cable
disconnected
z
Belt or chain is broken or
loose
z
Properly insert the terminal of 10
pin control cable into 10P control
socket
z
Change the new belt or chain.
z
Adjust the tension of belt or chain
Noise when
ultrasonic on
z
Check if the tooling horn
does not tighten with the
transducer kit
z
Check if the tooling horn
cracked
z
Check if without any
workpiece between the
working roller and tooling
horn
z
Tighten the tooling horn
z
Change a new horn
z
Put into the workpiece
The result of welding
are instable
z
Check if line source instable
z
Check if air source instable
z
Check if horn or working
roller is worn down
z
Check if horn uneven with
working table
z
Check if roller is bad level
z
Check if working roller or
horn turned too faster
z
Unsuitable roller pattern of
cutting design
z
Install a constant voltage regulator
as need
z
Let the air source stable
z
Change or re-grind the horn surface
z
Change the working roller
z
Adjust and control the accuracy of
the level within 0.02 mm.
z
Adjust the height of outer bracket
z
Reduce the working speed
z
Re-design the roller pattern or cutting
design