K-Sonic KS-2010, Руководство по эксплуатации

Страница: 49 / 54

48
5. Insert the workpiece in between the paper strip and O.P.P. strip.
6. Place down the working roller and puller roller by tread down the left side
foot switch.
7. Tread down the treadle switch and the puller rollers will move the work-piece
and strips of paper between working roller and horn.
NOTE: If any problem is happened, please refer to Item C “Methods of
Adjustments” or Chapter 8 “Trouble Shooting”.
B. Spot Sealing:
In some applications of KS series it may be necessary to use the spot sealing
system with a special roller. In this case, the process is as follows:
1. Lift up the working roller by tread down the left side foot switch.
2.
Insert the workpiece under the working roller and let the working roller
down. Then hold the workpiece in position where it is required to be sealed.
3. Step on the foot switch which is located on the right side of the treadle. At
this stage, only ultrasonic vibrate without the roller turning and only the
position which is directly underneath will be sealed, and the workpiece will
not run.
C. Methods of Adjustment:
In general, there are many factors affecting the working results, that depends
on what functions we choose. For example, when we work (continuous)
cutting to produce laces, the most important thing is to adjust the working
roller to fit onto the horn surface horizontally for uniform cutting. Next is to
adjust the puller roller and control the O.P.P. strip, material and paper strip
so that they run and paper strip so that they run together smoothly.
Also, adjust the pressure and the speed of the roller to obtain the best and
most efficient working performance. So far, we have always set the output
adjustment knob at scale 8, and only adjusted the pressure and speed
depending on the materials as well as thickness and design of the working
roller.