K-Sonic KS-2010, Руководство по эксплуатации

Страница: 50 / 54

49
1. Output adjustment
The output adjustment is located on the front panel of generator.
The output knob is usually set at scale 8, if the work-piece melts excessively
(and it is difficult to reduce the roller pressure and speed), then rotate the
knob counter clockwise and reduce the power output.
2. Working Speed Adjustment
In KS series there are two motors to drive the working roller (linking to
puller roller) and horn assembly separately, so that it is necessary to
adjust the suitable working speeds on both by turning the knobs
accordingly.
3. Pressure Adjustment
Pressure is very important when used in sealing and stamping. It should
match working speed and amplitude of horn.
Also, the pressure of puller roller should be suitably adjusted, or puckering
will occur.
4. Some Supplementary Methods in Sealing
In sealing operations, there may be some material that punks and twists. In
this case, it will be helpful to change the paper tape to some plastic tape
(polyester polypropylene, etc.) Thus, reducing the frictional resistance
between the workpiece and horn.
For saving tape, we can join the tape to form a circle around the table, this
then is driven by the puller roller, and used continuously. But, it is necessary
to check frequently whether the tape is in good condition.