K-Sonic KS-2010, Руководство по эксплуатации

Страница: 47 / 54

46
E. Fit a new horn, or repair the horn by grinding the horn surface until a smooth
surface is achieved, then replace it.
Caution: The horn may only be grind 2 or 3 times.
F. After changing the tooling horn, the horn surface should be checked to see
whether it is paralleled to the table surface or not. If it is not, then adjust the
six screws in the horn holder to the correct position.
Notes: the level of the HORN has been adjusted properly before it leaves the
factory. Adjust it with care until an inclined level is found by
measurement.
If the level of the HORN must be adjusted, please use the Dial
indicator
（
at least 0.01mm resolution
）
for adjustment and control the
accuracy of the level within 0.02 mm.