3
Insert the silica gels.
0
Be sure to insert the provided silica gels in
the position as shown in the diagram.
A
Loosen the screw and lift up the clamp.
B
Take out three silica gels from the aluminum
bag, and insert them into the back of the heater
(as shown in the diagram).
0
After inserting the silica gels, check that they
are not touching the heater.
C
Fix the silica gels firmly with the clamp, and
fasten the screw.
0
Turn the clamp until the silica gels are
secured, followed by tightening the screw.
.
Silica gel
x3
Screw
Clamp
Clamp
Heater
Heater
Fasten the silica gels firmly
with the clamp
Memo :
0
During reconnection or re-installation after
repair or maintenance, make sure to replace the
silica gels with new ones.
0
Consult your dealer on the replacement
procedures. Use the silica gel with a service part
number of LW40500-001A for the part to be
replaced.
Note :
0
If silica gel is not inserted, the camera lens and
dome cover may turn foggy, and the camera
image may not turn out clear.
0
When installing on a rainy day, ensure that
raindrops do not enter the interior.
4
Mount the dome cover to the camera.
0
Use the screws (x4) to mount the dome cover
to the camera. When installing the dome
cover, make use of the three catches and the
center mark of the cover as a guide. Install
such that the central mark appears above the
JVC mark of the camera.
.
Center
mark
(facing the JVC mark)
Position alignment catches (x3)
Note :
0
Check that there is no dirt or dust inside the
dome cover before mounting.
0
When installing on a rainy day, ensure that
raindrops do not enter the interior.
0
When mounting the dome cover, temporarily
secure the four screws and then tighten.
0
As a guide, tighten the screws to 0.5
N·m to
1
N·m (5
kgf·cm to 10
kgf·cm). If the screws are
insufficiently tightened, the dome cover may fog
due to moisture penetration.
5
Remove the cable connection cap.
0
Remove the cap on the arm of the camera.
.
Cable
connection cap
6
Pull out the cables from the cable
connection hole.
0
Pull out the cables (except the fall prevention
wire) of the camera from the cable
connection hole.
28
Installation and Connection Preparations (VN-H657WPU)
Moun
tin
g
the
Ca
m
era
