21
English
Basic Settings
7
Crossover frequency—“CROSS (crossover)”
Small speakers cannot reproduce the bass sounds efficiently. If
you use a small speaker in any position, this unit automatically
reallocates the bass sound elements assigned to the small
speaker to the large speakers.
To use this function properly, set the crossover frequency level
according to the size of the small speaker connected.
• If you have selected “LRG (large)” for all speakers, this
function will not take effect.
Select one of the following settings:
80Hz
: Select this frequency when the cone speaker unit
built in the speaker is about 12 cm.
100Hz
: Select this frequency when the cone speaker unit
built in the speaker is about 10 cm.
120Hz
: Select this frequency when the cone speaker unit
built in the speaker is about 8 cm.
150Hz
: Select this frequency when the cone speaker unit
built in the speaker is about 6 cm.
200Hz
: Select this frequency when the cone speaker unit
built in the speaker is less than 5 cm.
Notes:
• “100Hz” is the initial setting. If you have already changed the
setting, another frequency will be shown.
• Crossover frequency is not valid for the HEADPHONE mode.
7
Low frequency effect attenuator—“LFE”
If the bass sound is distorted while playing back software
encoded with
Dolby Digital
or
DTS Digital Surround
, set the
LFE level to eliminate distortion.
• This function takes effect only when the LFE signals come in.
Select one of the following settings:
0dB
: Normally select this.
–10dB
: Select this when the bass sound is distorted.
Note:
• “0dB” is the initial setting. If you have already changed the
setting, “–10dB” will be shown.
SPK.
DIGITAL AUTO
VOLUME
L
R
SPK.
DIGITAL AUTO
VOLUME
DIGITAL L
R
SUBWFR
C
LS
RS
7
Dynamic range compression—“D.COMP”
You can compress the dynamic range (difference between
maximum sound and minimum sound) of the reproduced sound.
This is useful when enjoying surround sound at night.
• This function takes effect only when playing back a source
encoded with
Dolby Digital
.
Select one of the following settings:
OFF
: Select this when you want to enjoy surround with its
full dynamic range. (No effect applied.)
MID
: Select this when you want to reduce the dynamic range
a little.
MAX
: Select this when you want to apply the compression
effect fully. (Useful at night.)
Note:
• “MID” is the initial setting. If you have already changed the
setting, another setting will be shown.
SPK.
DIGITAL AUTO
VOLUME
DIGITAL
LFE
L
R
C
SUBWFR
LS
RS
7
Digital input (DIGITAL IN) terminals—“DGT”
When you use the digital input terminals, register what
components are connected to which terminals (DIGITAL IN 1/
DIGITAL IN 2). So, the correct source name will appear when
you select the digital source.
Set the appropriate digital terminal setting.
• Each time you press CONTROL
3
or
2
, the display changes
as follows:
1 DBS 2 TV
“
1 DBS 2 CDR
“
1 TV 2 DBS
“
1 TV 2 CDR
“
1 CDR 2 DBS
“
1 CDR 2 TV
“
(back to the beginning)
Notes:
• “1DBS 2TV” is the initial setting. If you have already changed
the setting, another combination will be shown.
• If you want to connect a CD recorder to the digital input
terminal, change the source name to “CDR” from “TAPE.”
For details, see “Changing the Source Name” on page 12.
SPK.
DIGITAL AUTO
VOLUME
L
R
EN19-24RX-DV3SL[UG]2.pm5
02.8.8, 2:21 PM
21
