(No.22023)1-7
3.1.3 Removing the rear panel
(See Fig.5)
• Prior to performing the following procedures, remove the top
cover.
(1) From the back side of the main body, remove the strain re-
lief from the rear panel in the direction of the arrow.
(2) Remove the twenty three screws
E
attaching the each
board to the rear panel.
(3) Remove the four screws
F
attaching the rear panel.
Fig.5
3.1.4 Removing the DSP board
(See Figs.6 and 7)
• Prior to performing the following procedures, remove the top
cover.
(1) From the back side of the main body, remove the four
screws
G
attaching the DSP board to the rear panel. (See
Fig.6.)
(2) From the top side of the main body, disconnect the DSP
board from the connector CN611 on the DSP connector
board. (See Fig.7.)
(3) From the left side of the main body, lift the DSP board in the
direction of the arrow and disconnect the card wire from the
connector CN602 on the DSP board. (See Fig.7.)
(4) Take out the DSP board.
3.1.5 Removing the video jack board
(See Figs.6 and 7)
• Prior to performing the following procedures, remove the top
cover and DSP board.
(1) From the back side of the main body, remove the four
screws
H
attaching the video jack board. (See Fig.6.)
(2) Disconnect the card wire from the connector CN402 on the
video jack board and take out the video jack board. (See
Fig.7.)
Fig.6
Fig.7
F
Rear panel
E
E
F
F
E
Strain relief
F
H
Rear panel
G
DSP board
DSP connector
board
Card wire
Card wire
Video jack
board
CN611
CN402
CN602
