
50
CONNECTION TO THE MAINS
The appliance is designed for the operation with a one-
phase supply voltage of 230 V.
The electrical connection must be carried out acc. to the
valid standards and the relevant legal prescriptions.
Before the execution of the electrical connection make
sure that
- fuselage and house installation are designed for the
max. load of the appliance (see typeplate);
- the house installation is provided with a correct earthing
that will also correspond to valid standards;
-
socket and two-pole switch will also be easily accessible
if the appliance is switched on.
The connection must be carried out direct, i.e. without
plug connection. For that there must be provided between
appliance and power supply a two-pole switch with a
gap of at least 3 mm between the contacts, which is
designed for the load of the appliance and corresponding
with the valid standards. The yellow-green earthing
cable must, however, not be interrupted by a switch.
The brown phase cable (starting at terminal „L“ on the
terminal board of the cooker) must always be connected
to the power supply phase line. The power supply cable
is to be installed in a way that no position will reach a
temperature exceeding 50
°
C above room temperature.
If there is need to replace the power supply cable, do
please make use of cable type H05RR-F with a cross-
section designed for the load of the appliance. The little
yellow-green earthing cable must be longer by about 2
cm than the phase cable and the neutral conductor (fig.
19).
After completion of the electrical connection check all
heating elements by switching them on for about 3
minutes.
The producer rejects any liability for the case that
the afore-mentioned measures for the prevention of
accidents will not be complied with.
Fig . 19
earthing cable (yellow-
green)
Phase