Juniper SRX 5800, Руководство по оборудованию

Страница: 264 / 536

To remove the craft interface (see Figure 111 on page 265 ):
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Detach any external devices connected to the craft interface.
3. Using the Phillips (+) number 2 screwdriver loosen the captive screws at the left and right corners of
the craft interface faceplate.
4. Grasp the craft interface faceplate and carefully tilt it toward you until it is horizontal.
5. Disconnect the ribbon cable from the back of the faceplate by gently pressing on both sides of the
latch with your thumb and forefinger. Remove the craft interface from the chassis.
Figure 111: Removing the Craft Interface
Installing the SRX5800 Services Gateway Craft Interface
Before you begin installing the craft interface into the services gateway:
•
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See “Prevention of
Electrostatic Discharge Damage” on page 505 .
Ensure that you have the following available:
•
ESD grounding strap
•
Phillips (+) number 2 screwdriver
265